The ToneMatch power supply provides power for the T4S/T8S mixer.
System setup
Applies to:
- Insert the power supply cable into the T4S/T8S power port.
- Insert one end of the AC power cable into the power supply.
- Insert the other end of the power cable into a live AC power outlet.
- Switch the power switch to the ON position.
Note: The power supply included with the T8S is required for operation of the T8S. The power supply is not included with the T4S, it can be used but is not required for operation.
Note: The T8S cannot be connected digitally and cannot be powered by the L1 Model 1S/II.
- Make sure the L1 Model 1S/II and T4S are powered off and the T4S master volume control is set to minimum.
- Insert one end of the ToneMatch cable into the power port/Digital Main Output R on the T4S. Insert the other end of the ToneMatch cable into the ToneMatch port on the power stand.
Note: To connect the T4S to two L1 Model 1S/II power stands, connect a second power stand to the Digital Main Output L port on the T4S using a ToneMatch cable. - Turn on the mixer and then turn on the L1 Model 1S/II power stand.
- Connect your instruments/microphone and adjust levels.
- Make sure the device you are connecting to and the T4S/T8S are powered off and the T4S/T8S master volume control is set to minimum.
- Using XLR balanced cables, connect one or two devices to the XLR stereo outputs of your T8S.
Note: The T4S/T8S can be connected to a device via the Analogue R Output port using a 1/4” TRS cable (sold separately). Plug the other end of the TRS cable into the Analogue Input port of the device. To connect the T4S/T8S to two devices, connect a second device to the Analogue L Output port on the T4S/T8S using a 1/4” TRS cable. - Connect a ToneMatch power supply to the power port of the T4S/T8S and plug it into a live AC outlet.
- Turn on the T4S/T8S mixer and then turn on the device.
- Connect your instruments/microphone and adjust levels.