Enabling standby (low power) mode

Applies to:

SoundTouch® SA-5 amplifier

You can enable standby (low power) mode by removing the Ethernet cable and disabling Wi-Fi and Bluetooth®. This will prevent the amp from connecting to your network and any Bluetooth device, as well as preventing the amp from being controlled by the SoundTouch® app until Wi-Fi and Bluetooth are re-enabled.

On the SA-5 amplifier, press and hold the Control button until the Wi-Fi indicator turns off

Within a few minutes, the unit will enter standby mode

To re-enable wireless network capabilities, including Bluetooth, press the Control button

Enabling standby (low power) mode

Applies to:

Did this information help?