Order by 21st December to get your delivery by Christmas for metro areas and by 16th December for other regions.
 

Adding another music source

You can use another audio device, such as a portable digital music player, with your system. This requires using a stereo audio cable with a 3.5 mm (1/8-inch) mini plug (not provided) that is appropriate for the connected audio device that plugs into the AUDIO INPUT connector on the back of the SoundDock® system.

Insert the audio cable from your audio device into the AUDIO INPUT jack on the back of the SoundDock® system. If your iPod® or iPhone® is not docked, the connected device will play automatically once it sends an audio signal to the SoundDock® system

Set the connected device to full volume, and then use the SoundDock® system volume buttons to adjust the level

Note:

on the sounddock® remote, press and hold play/pause for 3 to 5 seconds to enable the connected device to play through the system if your ipod® or iphone® is charging in the dock

Play/Pause

The iPod® or iPhone® charges while you are playing audio from the connected device

on the remote, press and release play/pause to switch from the connected device to your docked ipod® or iphone®

Play/Pause

Was this helpful?

Submit

Thank you for submitting your comments.